HOME

NiceMite
Stuff you didn't know you needed.
 
 
     
Lightmite TB

Lightmite TB is a trackball lighting solution. It allows a neat and quick way to light translucent trackballs using superbright LEDs. The bare pcb through a fully assembled unit is available. The assembled unit is available in 5Volt and 12Volt. The high flux led allows very even bright lighting and the dimmer allows for control over the intensity level so you end up with an nicely lit trackball without the glare. Connect your positive and negative leads to the terminal block on the Lightmite and tap into either a 5V or 12V source. Do-it-yourselfers can also assemble the board with 4 individual led's.(If using 4 leds, do not run at a voltage higher than 5v when using a dimmer, dimmer is not rated for more than 5v) Boards are labeled showing all components on the front, however the led(s) can be mounted to the bottom to allow easier access to the terminal block and dimmer.

Mounting: Center the LED under the trackball. Using one of the two mounting holes on the board, mark a location to drill. Drill a 3/32" pilot hole. Attach the trackball with the supplied screw and spacer. Alternatively a PCB mounting foot can be used in order to take advantage of an existing mounting hole since it allows for some adjustment. See pictures. PCB mounting foot sold seperately.

Watch the dimming video!!!!

Product Price

Plain Board

(If using 4 leds, do not run at a voltage higher than 5v when using a dimmer, dimmer is not rated for more than 5v)

$2.49
 

Board with Terminal Block and Dimmer

(If using 4 leds, do not run at a voltage higher than 5v, dimmer is not rated for more than 5v)

$3.49
 

Complet Unit

Assembled

Includes Mounting Hardware

$6.99
Color
Volts